Product Description

Specification Parameter

Technical Support


The introduction of PRO800 Plus (7041+3041)

PRO800 PLUS User Manual


Your content goes here. Edit or remove this text inline or in the module Content settings. You can also style every aspect of this content in the module Design settings and even apply custom CSS to this text in the module Advanced settings.
The problem of distance

Answer: 1. Adjust the channel, it is recommended to set it in CH1 to CH5; 2. Set up the transmitter and receiver to a height of 1.5-2 meters from the ground, and switch the receiver to high gain mode; 3. Adjust the transmitter and receiver’s antennas to a 90° angle, like a fan shape.

The transmitter is connected to the camera and cannot detect the signal, which can only be detected by connecting the monitor.

Answer: 1. Confirms what the SDI resolution is, depending on whether it is in the range of 1080p 60-720p 60. 2. Check whether the status of the transmitter’s video indicator light is yellow on. 3. If the yellow light is not on, then replace the SDI video sources and SDI cable; 4. Following the above operation, the transmitter’s video light(yellow) is still not shown. Please use the HDMI video source to check; 5. Extend the distance between the transmitter and the receiver to 2 meters, and the receiver’s HDMI and SDI interfaces output video signals simultaneously for verification.

The problem of disconnection

Answer: 1. Replacement of the antenna; 2. The default setting of the PRO200 is the high gain mode, and at close range, it can be switched to the low gain mode for verification; 3. The channel can be switched to low, medium and high to test.

Mosaic, Katon appear during use.

Answer: 1. The transmitter and receiver should be set as high as possible, to more than 1.5-2 meters; 2. The antenna should be fan-shaped, with the antenna facing forward for best transmission; 3. The receiver should be moved closer to the transmitter; 4. The obstruction between the receiver and transmitter should be reduced.